All Rolls By GM Sent only to GM via WOTC module NPCs

I used a purchased module to create a campaign. Out the Abyss. Upgraded to Pro (accidently but that fine). Last we ran and all of the npc rolls from npc sheets whisper to GM. I went to check the standard settings for the game and I set it to never whisper during the game. It did not effect the outcome. Checking about a week later- now there is no setting toggle for whispering in the settings. The behavior remains the same. NPCs pulled in from the Monster Manual now send to the table, but NPCs from the module still do not.

Hi Chuckles! There are a few steps in setting whisper status that can be easily overlooked. Here is my one-stop guide: Note that the whisper settings are attached to each individual sheet, there is no actual game setting. These instructions are for changing the defaults for all the character sheets in the game, then applying the settings to all existing sheets. Note that this will also change your PC sheets - you will have to manually change them to a different setting if one is preferred. Here are the ways to toggle this behavior: Always Whisper Go to the Campaign Settings Page Choose "Always Whisper Rolls" under "WHISPER ROLLS TO GM" in the Default Sheet Settings Save Load your game Go to the settings tab on the right and look under Miscellaneous, where you will find a button that says Apply Default Settings. Press it. Choose to update the Whisper settings. Wait a minute or two for it to resolve. There is a thin easy-to-miss progress bar. Never Whisper There's a bug in the game settings that doesn't recognize "Never Whisper Rolls", possibly because it is trying to write a blank value. The solution is to use Whisper Toggle. The default is public, so once this is set, all rolls should show. Go to the Campaign Settings Page Choose "Whisper Toggle" under "WHISPER ROLLS TO GM" in the Default Sheet Settings Save Load your game Go to the settings tab on the right and look under Miscellaneous, where you will find a button that says Apply Default Settings. Press it. Choose to update the Whisper settings. Wait a minute or two for it to resolve. There is a thin easy-to-miss progress bar. Query Whisper The default is public, so once this is set, all rolls should show by default unless you choose otherwise. Go to the Campaign Settings Page Choose "Query Whisper" under "WHISPER ROLLS TO GM" in the Default Sheet Settings Save Load your game Go to the settings tab on the right and look under Miscellaneous, where you will find a button that says Apply Default Settings. Press it. Choose to update the Whisper settings. Wait a minute or two for it to resolve. There is a thin easy-to-miss progress bar.    7. Have fun!