I messed up and used the same attribute name inside and outside a fieldset. attr_DmgBonus is used inside repeating_weapons and is also used outside the fieldset. Some sheet authors say it shouldn't matter since the attribute within the fieldset would in theory be unique since it resides within the repeating section. And for the most part there doesn't seem to be any issues. But, I have an example where this is a problem; In this particular case, making a sheet roll from within the repeating section works as expected since it pulls the attribute data directly from within the fieldset. However, if I make the same sheet roll using an "off-sheet" macro (just calling the repeating sheet roll by it's button name) it appears that it checks and uses the non-repeating attributes first instead of the identically named repeating attribute. ;-( How can I go about using sheetworkers to fix this? I have a function that checks the current version of the sheet and can run a "attribute swap" function if the sheet is an older version(pre-swap). I would like to replace the non-repeating DmgBonus with StrengthDmgBonus. Any value for DmgBonus should be migrated to StrengthDmgBonus. After this is done, DmgBonus should be deleted. Is this possible? TIA